Insulation is in!

[Nick Thegreek]

Finally got the walls insulated with foam core with metalized film over that I added 6 inch thick R-19 fiberglass so it should be nice and cozy and pretty much sound proof. Also insulated the bed strutcure walls with foam core to help with keeping noise down.

Now on to installing the plywood on the interior walls.

Okay finally snapped  a few pix to show the ongoing work. I used cardboard to make templates for the rear corner walls and also the beginnings of an overhead console. In the pix you see the sections that are temporally held in place to set the arch of the console while the liquid nails dries.The rear corners

Fiberglas over foam core insulation

First piece of the console

Additional piecesof the console added to set the arch once dry the screws will come out and the whole console will be taken out and covered in black carpet.

This shows the place where the partition is placed once the walls are in place -It will divide the storage area under the bed in two.

This shows the rear corners used 1'4 inch OSB because it is flexible

[Nick Thegreek]

Thanks Tony and Joy, still have a long way to go yet.