Still at it on my Dodge custom van

[Nick Thegreek]

 Okay finally got the foil backed foam core insulation in the ceiling-it was rough going when the temperature was in the low 20's and it was sleeting. Had to take a few breaks to get my hands warm.

Found a novel idea for my doors that go in front of the bed partition ! I had a set of cast aluminum wall sconces that looked like old wrought iron. I gut of the stem that holds the candle holder- ground down the tabs on the back and center drilled them. I will find a pair of brass or bronze drawer pull knobs and mount them on the door panels- this will ad to the old sailing ship theme.

Also started to make the wall cabinet I was going to mount a small stainless sink  in it but have decided not to go with that plan mainly because I would have to punch a hole through the floor of the hand for a drain.

Gonna try to snap a few pix today and post later. Also got the materials for the walls in the bed area and ceiling going with rustic looking wood grained paneling and carpet for the rest of the van and door panels.

[Nick Thegreek]

Here are the pix of the cabinet

http://goodoldrvs.ning.com/profile/NickThegreek