It may be time to replace the 30-year-old HW heater in my Allegro, but I'd like to see if I can nurse it along one more season. There are many other things competing for the $350 it would cost to replace it.

It worked sort of okay last year. It stayed lit, but the thermostat wasn't working properly. It would get hot enough to open the relief valve and/or hit the cut-out switch. I have a new thermostat for it, but now it's not staying lit with the door closed.

With the door open it has a nice strong flame. When I close the door I can hear the flame choke off a bit. The electronic ignition will start to click (I guess because it doesn't think the flame is lit?) and it will eventually die. I assume the flame gets its air through that vent on the front? I cleaned that out last season when I first put the thing on the road because it was clogged with wasp nests. I can't see it being clogged up again.

Any suggestions beyond the vent?

Thanks!

Views: 154

Replies to This Discussion

You've probably done this but make sure all the burner holes and pilot orifice's are clean if it has a therm-o-couple  make sure its clean and adjusted. 

Actually I haven't really messed with it at all. I'll check those things out. I was going to try to open up the air holes some more but the adjustment screw has corroded and become one with the tube.

Ill bet mine's in the same condition. 37 years old and I haven't tried it out yet. Just something I haven't had the need for yet but, I'll probably start on mine soon. I'm wanting to hit a few races this year and plan on camping at the track at least two of them.

Mine had been sitting for about 6 years before I got it in late 2013. Inside the door is very rusty, but not rust-through-type rusty. Just covered in it, if you know what I mean. I did have it apart last year but I really don't recall why. I replaced the thermostat with an adjustable one at that time, too. It only works intermittently so the manufacturer sent me another that I've yet to install. I had to replace the relief valve, too, because it wouldn't seal up anymore after the first time it overheated.

Anyhow, I fired it up again last night with the city water hooked up instead (when I posted I was was just using the fresh water tank). I know city vs. tank has nothing to do with it, but the stupid thing worked flawlessly. Stayed lit and shut off when it should. The adjustable thermostat appears to be working when I adjust it, but even on its lowest setting the water is uncomfortably hot, but I guess when you have a small tank you have to keep it pretty hot in order to make it last longer.

Maybe there was air in the propane lines or something else related? I replaced the regulator just before I posted, too, but the stove and furnaces seemed to be working okay. It took a while for the fridge to want to stay lit, though. Hmmm....

Your probably right on the air in the line. My furnace decided to quit working over the winter. it worked great in November. t's way,way down on my to do list though.I have about 30 yards of concrete to get poured before I can put money into the heater.

I know of 2 venting mods for old WHs but none for the atwood 6 that I see in the pictures.  you could try modifying the lower hinges outward some to allow more air in.  that burner flame should be blue with and outer and inner cone.  adjust air to where shes noisy then close to where she just quiets to a slight roar...if there is such a thing

That's pretty much the way it is - the sounds are exactly as you described. It went back to its old ways last night - wouldn't stay lit. It seems ambient temp has something to do with it. 

Does your unit have a pilot adjust on the gas valve if it does adjust the pilot flames little higher mine did that I ended up replacing it  I couldnt adjust the flame

RSS

Members

HOW TO MEMBER POSTS

  •         How To Links 

-Search Good Old RV's

-Start a New Group 

-Roof Repair Photos & Products

-Repair an RV Roof

-Pick Roof Sealer   

-Understanding RV Electrical Systems 

-Get RV Insurance   

-What to Look For When Buying a Used RV

-Jack Installs Fuel Injection in his Dodge 

 RV ARTISTS 

 

 Artist Roads                                              

                      

JOIN US AT GOOD OLD RVS

If you love classic and vintage RVs then come Join us. Come on in and have some fun. JOIN HERE NOW

Forum

Starcraft Ceiling Repair

Started by Donald Morgenroth in RV Repair & Maintence Mar 18.

Replacing controller ,? And inverter 1 Reply

Started by Dave King in Vintage & Classic RV Restoration & Purchase. Last reply by Rick Cornell Apr 27, 2023.

Sway Bar Links 2 Replies

Started by Grey Wolf in RV Repair & Maintence. Last reply by Grey Wolf Apr 22, 2023.

Events

Videos

  • Add Videos
  • View All

JOIN US - COME ON IN!

If you love classic and vintage RVs then come Join us.

 Come on in and have some fun.      

 Dedicated to a simpler, more rewarding and fun way of life in a Good Old RV... 

Vintage Travel Trailers, Vintage Campers, Camper Restoration, Bus Conversions, Vintage RV Forums, Old RVs, Tiny Homes, Boondocking

A work of art by member Paige Bridges

+++++++++++++++++++++++++++++

 Disclaimer - Please Read it

Enjoy this site and use it totally at your own risk.

By using or viewing this site YOU agree to Hold Harmless anyone associated with it including other members. Also, YOU agree that YOU are solely responsible for ANY and ALL actions, results or damages. Members "opinions" are just that and any repair or alteration comments or recommendations are by folks who are not licensed repair  or mechanical professionals. Any repairs or modifications you do totally at YOUR OWN RISK. Use licensed professionals for all work to avoid possible serious injury or damage. Use  banks for purchases.  Have fun!

Copywrite & Trade Mark Registered GoodOldRV© ,GoodOldRVs©, GoodOldRVs.com©,GoodOldRVs.net©,GoodOldRV.Com©

© 2024   Created by Jimco_W001.   Powered by

Badges  |  Report an Issue  |  Terms of Service