Hello. I am new to this Forum. I am restoring an 87 Holiday Rambler. It is in ok condition. However I can't get the jack to retract. They have been extended for 6 years.

My question is does the motor have to be running to get them to retract ? Any help would be wonderful. I need to get them up so I can get it to the mechanic.

Views: 894

Reply to This

Replies to This Discussion

Phillip, not an expert on this topic. Hopefully, one of our members will chime in. Last leveling jacks I had were of course hydraulic with heavy springs that caused them to retract once the pressure was eased off the hydraulics, i.e. put in retract mode. So I guess I'd check hydraulic fluid level in the cylinder, power to the hydraulic unit. I suspect that the jacks are subsided into the ground so someone would have to jack up the frame of the HR, properly supporting in several place it so if it falls no one is hurt or even seriously injured. Best left to a professional to avoid serious injury or worse (disclaimer-do at your own risk) then apply your favorite penetrating lubricant, let soak in over night, and try and retract the units. Probably will have to drain and refill and bleed the hydraulic units since sitting so long will have air and maybe moisture in the fluid.   Members, got any better ideas for Phillip on this? Chime in...

Thanks Pat. I am excited to get her on the road again. I do want to get her to a mechanic to give her a once over to see if there are any serious issues. I just cant get the jacks up. The jacks are the ones with the springs on the sides. It appears to have power at  to the switch plate on the dash board.  When I move the floor mounted levers to retract nothing happens. Actually that is not true. The first time I moved them to retract it seemed to drop them down some but they won't come up any further. If I move the levers to extend I can hear a clicking noise come from under the lever console but they don't extend. I will look for the cylinder and check the level. I just keep thinking there must be some sort of relief valve to retract them.

 I have not been underneath yet to look at the lines.

Thank you again for your assistance.  

There are 2 basic types of leveling systems available on the Holiday Ramblers.

Full electric and Electric over Hydrolic.. 99% of the time the Engine has to be running to extend or retract

leveling jacks. Some of the later models had a switch to retract and extend without the engine running,,BUT it put a serious drain on the Battery. I would make sure you dont have rust or dirt accumilated around the *slides for when they do retract,, it doesnt take much to bind them up.

Thanks Lakota. I thought that might be the case as far as the motor needing to be running. I think I have to check the fuel filter at the carb. It ran last week for the first time in 6 years . Only for about a minute but that may have been enough to foul the filter. The tank appears empty. One thing at a time.... right ?

I hope everyone has a wonderful and safe Holiday weekend. I will post pictures of my diamond in the rough soon.

Phillip, let us know how it goes...

Holly Cow !!!!!!   I just spoke to someone at HWH and they said it would be 6 to 8 weeks before anyone could call me back to answer a question. I said  " Uh never mind " .

 So next step is pulling the fuel filter and changing it then see about starting the puppy back up. Maybe that will help with the jack retraction. I'll keep you all posted.  Cause I know everyone is on pins and needles. LOL.

I had the pleasure of speaking with an older gentleman who pulled in with a *Silver Eagle, ( nice old classic motorcoach). His leveling jacks are spring loaded and his will only operate UP or DOWN with his engine running and his DOORS CLOSED,,,He said its a safety feature of some sort. He said he had one in the front that was being a little testy and would shake and shutter and just be down right stubborn. It had turned out to be dust and crud that had accumilated around the slide cylinder. He says, going underneath after a long stay,, 2- to 4 weeks,, and just visually eyeball the slide cylinders.... He said BE VERY VERY CAREFUL AROUND THEM,,, The springs are under high tension when extended. He mentioned checking the connections around the solenoid to the elctric/hydrolic  motor for corrosion. And to see if the factory inline fuse is good from power source to the solenoid.  (sometimes previous owners cut the fuse out and just splice the wire back).

Just be very careful around the SPRINGS,,, they can and will take a finger or two if given the chance.

Thanks. Definitely good to know.

 

I am getting frustrated. According to everything I have read they should retract without the need of the pump. I am going to see if they are stuck in the asphalt. 

Got the front ones up. Crow bar. Just started going up. I'll need new springs on one. 

RSS

Members

HOW TO MEMBER POSTS

  •         How To Links 

-Search Good Old RV's

-Start a New Group 

-Roof Repair Photos & Products

-Repair an RV Roof

-Pick Roof Sealer   

-Understanding RV Electrical Systems 

-Get RV Insurance   

-What to Look For When Buying a Used RV

-Jack Installs Fuel Injection in his Dodge 

 RV ARTISTS 

 Paige's VintageTrailer Art  

 Paige's VintageTrailerFabric

 Artist Roads                                            Sandy's Stained Glasshttps://www.pinterest.com/pin/552605816752050167/     

                      

JOIN US AT GOOD OLD RVS

If you love classic and vintage RVs then come Join us. Come on in and have some fun. JOIN HERE NOW

Forum

Plumbing vents

Started by Sandy St.Louis in RV Repair & Maintence Jun 20.

1977 Itasca cruise control actuator 2 Replies

Started by Mark in Vintage Camper Parts For Sale. Last reply by Jack Wasmuth Jun 13.

Blog Posts

Balboa owners

Posted by Bill on May 19, 2020 at 8:11am

camper theft

Posted by Thomas S. Redding on May 18, 2020 at 11:19am

CAMPING

Posted by Eddie Marquez on May 5, 2020 at 2:34pm

"Easy" Loose Pipe Repair

Posted by Don Olson on April 26, 2020 at 12:08am — 1 Comment

Loose Pipe Fix

Posted by Don Olson on April 26, 2020 at 12:02am — 1 Comment

Videos

  • Add Videos
  • View All

JOIN US - COME ON IN!

If you love classic and vintage RVs then come Join us.

 Come on in and have some fun.         JOIN HERE NOW!

 Dedicated to a simpler, more rewarding and fun way of life in a Good Old RV... 

Vintage Travel Trailers, Vintage Campers, Camper Restoration, Bus Conversions, Vintage RV Forums, Old RVs, Tiny Homes, Boondocking

YOUR OWN GORVs T-Shirt!

A work of art by member Paige Bridges

Get your Good Old RVs T-Shirt HERE

+++++++++++++++++++++++++++++

 Disclaimer - Please Read it

Enjoy this site and use it totally at your own risk.

By using or viewing this site YOU agree to Hold Harmless anyone associated with it including other members. Also, YOU agree that YOU are solely responsible for ANY and ALL actions, results or damages. Members "opinions" are just that and any repair or alteration comments or recommendations are by folks who are not licensed repair  or mechanical professionals. Any repairs or modifications you do totally at YOUR OWN RISK. Use licensed professionals for all work to avoid possible serious injury or damage. Use  banks for purchases.  Have fun!

Copywrite & Trade Mark Registered GoodOldRV© ,GoodOldRVs©, GoodOldRVs.com©,GoodOldRVs.net©,GoodOldRV.Com©

© 2020   Created by Russell E Johnson.   Powered by

Badges  |  Report an Issue  |  Terms of Service