Paul
  • Male
  • United States
Share on Facebook

Paul's Groups

Paul's Discussions

Help dropping fuel tank ( gasoline)
2 Replies

 I have a 72 Grumman motorhome. The fuel tank needs to be dropped because I am not getting fuel to the carb. There are two pickups on the top of the tank. One goes to the engine and the other to the…Continue

Started this discussion. Last reply by Cassandra Krepp Apr 30, 2022.

Carb not getting gas
1 Reply

Hey all. I have a 72 Grumman motorhome with a 392 IH V8.The carb isn't getting gas.I connected a boat gas tank with a pump ball to the inlet ofthe mechanical fuel pump. That gave me gas but I'm not…Continue

Started this discussion. Last reply by Paul Sep 14, 2021.

 

Paul's Page

Latest Activity

Paul commented on Kirk C Hoffman's status
"I'm a bit late here but that's great!! How have you been? Mines still sitting in the yard waiting on me to get working on it again."
Jul 10, 2023
Cassandra Krepp replied to Paul's discussion Help dropping fuel tank ( gasoline)
"Just like most vehicles they give you just enough room. You might even cut a knuckle but it can be done. Put a floor jack underneath the tank so you can control how far and fast it comes down. Also put a 2+12+12 between tank and jack."
Apr 30, 2022
Paul's discussion was featured

Help dropping fuel tank ( gasoline)

 I have a 72 Grumman motorhome. The fuel tank needs to be dropped because I am not getting fuel to the carb. There are two pickups on the top of the tank. One goes to the engine and the other to the generator.there's also 2 sending wires on top.The problem is that the fuel lines run on top of the chassis rails under the floor. When the tank is installed, these fitting are up against the underside of the RV.I can drop the tank enough to maybe undo these. (See picture) The fuel lines are stopping…See More
Apr 28, 2022
Paul replied to Paul's discussion Help dropping fuel tank ( gasoline)
Apr 27, 2022
Paul posted a discussion

Help dropping fuel tank ( gasoline)

 I have a 72 Grumman motorhome. The fuel tank needs to be dropped because I am not getting fuel to the carb. There are two pickups on the top of the tank. One goes to the engine and the other to the generator.there's also 2 sending wires on top.The problem is that the fuel lines run on top of the chassis rails under the floor. When the tank is installed, these fitting are up against the underside of the RV.I can drop the tank enough to maybe undo these. (See picture) The fuel lines are stopping…See More
Apr 27, 2022
Paul replied to Paul's discussion Grumman - Load bearing walls or support needed? in the group International Harvester Chassis Rv's
"Hey Kirk, I hope you had a good Christmas, and the New Year is treating you well!"
Jan 17, 2022
Kirk C Hoffman replied to Paul's discussion Grumman - Load bearing walls or support needed? in the group International Harvester Chassis Rv's
"Hi Paul,       Haven't done much with the old Krager, I've been working on putting together a big air compressor to run my blasting cabinet. I got a piece of 12" channel iron and had to mount the compressor head and…"
Oct 27, 2021
Paul replied to Paul's discussion Grumman - Load bearing walls or support needed? in the group International Harvester Chassis Rv's
"Hi Kirk. It's been a crazy couple of weeks. Did you manage to get the Krager all stripped down yet? I decided to buy an old 1967 Sunbeam Alpine. It was an ebay classified. Sat at a coparts in PA. Long story but very frustrating from beginning…"
Oct 26, 2021
Paul replied to Paul's discussion Grumman - Load bearing walls or support needed? in the group International Harvester Chassis Rv's
"Hey Kirk. No. Life got in the way. I'm already to drop it but need to make the time. Hopefully in the next two weeks it'll get done and I'll post an update! Take care"
Oct 8, 2021
Kirk C Hoffman replied to Paul's discussion Grumman - Load bearing walls or support needed? in the group International Harvester Chassis Rv's
"Hi Paul,      Any luck on your gas tank problem? Haven't been on here much the past couple weeks, busy trying to get ready for Winter! I started taking the old Krager RV apart yesterday. Need to get it gone! That thing has a…"
Oct 7, 2021
Kirk C Hoffman replied to Paul's discussion Grumman - Load bearing walls or support needed? in the group International Harvester Chassis Rv's
"Hi Paul,      It would be nice if these so called "parts sellers" would post dimensions of the stuff they sell! But that would make life too easy!  My tank just has a steel pipe welded to the top corner of the tank.…"
Sep 22, 2021
Paul replied to Paul's discussion Grumman - Load bearing walls or support needed? in the group International Harvester Chassis Rv's
"Hey Kirk. So I have a filler neck without a thread. The cap I did buy a while back has the tabs that twist onto the neck. I dont know if the steel filler neck was also changed at some point before I got it. The amazon search did show a bunch of…"
Sep 21, 2021
Kirk C Hoffman replied to Paul's discussion Grumman - Load bearing walls or support needed? in the group International Harvester Chassis Rv's
"  Hi Paul, I dug through my bucket of gas caps and the only one I found had the threads on the outside  of the cap, so it would screw into a filler neck instead of over it. The Amazon one is called a  Stant Saddle Tank Fuel cap black,…"
Sep 21, 2021
Paul replied to Paul's discussion Grumman - Load bearing walls or support needed? in the group International Harvester Chassis Rv's
"Hi Kirk If you can find that cap on amazon again and can tell me what the description said I'm sure I'll be able to find it. No need to copy the link. Just the main title - like brand and basic description should do it. Dont go digging…"
Sep 21, 2021
Kirk C Hoffman replied to Paul's discussion Grumman - Load bearing walls or support needed? in the group International Harvester Chassis Rv's
"Hi Paul,         I just looked online for a replacement cap, I found one on Amazon tried to add it to this post but it didn't recognize the format. It was $23 dollars and some cents. I'll have to dig through my…"
Sep 21, 2021
Paul replied to Paul's discussion Grumman - Load bearing walls or support needed? in the group International Harvester Chassis Rv's
"Hey Kirk.Just one picture came through. The top of the cap. I should be able to find on based on that. Thanks for taking the time to help.My tank is probably setup the same way as yours. Sorry for the enormous picture. I Cant resize on my…"
Sep 18, 2021

Profile Information

You And RVing
Part Time RVer
What's your camper's Brand, i.e. Travco, Shasta, etc.
Grumman
City and State where you are located. Do not use zip code, you know what it means but it means nothing to the rest of us.
St.Petersburg Florida
Anti-spam question: 4 plus 1 equals what?
5

Comment Wall

You need to be a member of Good Old RVs to add comments!

Join Good Old RVs

  • No comments yet!
 
 
 

Members

HOW TO MEMBER POSTS

  •         How To Links 

-Search Good Old RV's

-Start a New Group 

-Roof Repair Photos & Products

-Repair an RV Roof

-Pick Roof Sealer   

-Understanding RV Electrical Systems 

-Get RV Insurance   

-What to Look For When Buying a Used RV

-Jack Installs Fuel Injection in his Dodge 

 RV ARTISTS 

 

 Artist Roads                                              

                      

JOIN US AT GOOD OLD RVS

If you love classic and vintage RVs then come Join us. Come on in and have some fun. JOIN HERE NOW

Blog Posts

Skyline Group

Posted by robert & diane creech on November 23, 2024 at 6:30am

1970 Prototype Revcon 240 Needs a new home

Posted by Bonnie Weir on July 13, 2024 at 2:55pm — 2 Comments

1973 Dodge Hall GTC

Posted by Alfonso Vilches on July 7, 2023 at 8:18pm

Parts for a 1978 Allegro Motorhome

Posted by Ellen (Ellie) Rice on December 9, 2022 at 6:24pm — 1 Comment

Wanted side lights

Posted by David & Misty Preciado on June 10, 2022 at 6:18pm — 2 Comments

Events

Videos

  • Add Videos
  • View All

JOIN US - COME ON IN!

If you love classic and vintage RVs then come Join us.

 Come on in and have some fun.      

 Dedicated to a simpler, more rewarding and fun way of life in a Good Old RV... 

Vintage Travel Trailers, Vintage Campers, Camper Restoration, Bus Conversions, Vintage RV Forums, Old RVs, Tiny Homes, Boondocking

A work of art by member Paige Bridges

+++++++++++++++++++++++++++++

 Disclaimer - Please Read it

Enjoy this site and use it totally at your own risk.

By using or viewing this site YOU agree to Hold Harmless anyone associated with it including other members. Also, YOU agree that YOU are solely responsible for ANY and ALL actions, results or damages. Members "opinions" are just that and any repair or alteration comments or recommendations are by folks who are not licensed repair  or mechanical professionals. Any repairs or modifications you do totally at YOUR OWN RISK. Use licensed professionals for all work to avoid possible serious injury or damage. Use  banks for purchases.  Have fun!

Copywrite & Trade Mark Registered GoodOldRV© ,GoodOldRVs©, GoodOldRVs.com©,GoodOldRVs.net©,GoodOldRV.Com©