Comment

Comment by So ska noname on July 19, 2015 at 2:41pm

I will leave it unwrapped so I can see it. Thank you.

Comment by Rich Thomas on July 19, 2015 at 2:38pm

you can, I always wrapped it up backwards on split bolts ( sticky side out) because the glue on tape makes a mess when you open it up for inspection or adding a wire. It looks like the power conductor is shielded fairly well so I would consider it as a personal preference.  

Comment by So ska noname on July 19, 2015 at 2:36pm

Is good. The rest of it looks good so that's a minor fix. The hard part is squeezing Into the space to work. No one has mentioned anything else so That's a big plus. Then onto to plumbing leaks--plumbers adhesive and cleaner on shopping list. I marked where need fixed.

Comment by Russell E Johnson on July 19, 2015 at 2:30pm

Good catch all, I missed that conglomeration all together.  Sorry So ska, its needs to be tied together properly.

Comment by So ska noname on July 19, 2015 at 2:25pm

Should I add electrical tape? I pick one up tomorrow. More shopping lol

Comment by Rich Thomas on July 19, 2015 at 2:23pm

You should be able to do it with one. you just take the nut off slide it over the conductor where it's twisted together and install the nut, tighten and you should be good to go.

Comment by So ska noname on July 19, 2015 at 2:17pm

I am taking a picture of your comment when I go to hardware store. Thank you. It's worked this way a long time, but it want be sure. Do I need just one split bolt connector for the grounds green wires.

Comment by Rich Thomas on July 19, 2015 at 2:13pm

So ska looking at those frame grounds the twisted wiring on the green leads I would highly recommend as John T noted to either supply a buss bar for those connections or on the cheap and, just as good electrically;  buy a split bolt connector and place it on those twisted wires.    

Comment by Russell E Johnson on July 19, 2015 at 12:29pm

That looks great, it should give you many years more of wonderful service