I have had the bed section partition walls made for weeks now. But I had a CD player/radio that I wanted to use in the van. I shaped up a board with a form fitting hole to accept the radio and cut a matching hole in the front partition to hold the radio- obviously I needed 110 volts to run it . I am planning on making a section  of extension cord that will attach to the beaker box and then this will feed the receptacles in the van. Can't install this stuff until I get the walls done.

I thought I would post a few pix of various projects I have done. This dining room table and chairs was bought at an auction in SC for $15 of course it was in broken pieces after 3 months of working on it and making parts for the chairs this is what I ended up with.…

After days of nasty weather I finally got the overhead console in the Dodge van project. Here are some pix.…

Finally got the walls insulated with foam core with metalized film over that I added 6 inch thick R-19 fiberglass so it should be nice and cozy and pretty much sound proof. Also insulated the bed strutcure walls with foam core to help with keeping noise down.

Now on to installing the plywood on the interior walls.

Okay finally snapped  a few pix to show the ongoing work. I used cardboard to make templates for the rear corner walls and also the beginnings of an overhead console.…

As if I don't have enough projects going ,I recently got a 1995 Dodge B1500 cargo van. It is a V-6 which is good for me. Runs and drives super. Started working on the in interior to insulate and panel the walls with plywood. Just finsihed up the rear inside corners today. The wood floor is down too.

Plus still laying out the patterens for the woodgrain I will be putting on my old GMC camper.

I have been intocustom vans for a long time so this one will be the 7th or 8th that I…