I don't think I like the direction my garage contents are going. It's starting to look waaaaay too much like a mechanics' cave. When there is a torn apart carburetor in the middle of the room, and dirty grimey rags everywhere, the smell of gas despite draining it before bringing it in...grease tracks on the floor, all kinds of cans of cleaners and lube sprays here and there,...and should I mention the mower deck torn apart on the other side of that? I s'pect next year I'll have a full…Continue
Posted on September 10, 2017 at 6:56pm — 3 Comments
.....way too much gas. My carburetor is flooding out, brother says it's due to a sticky float. Well, okay.....
He says this is a 4 barrel carburetor, but cannot tell me the make. I can't see anywhere on this what the make etc. is, to look anything up on it.
He also says "I would just remove those hoses and those 4 bolts and take the carb out to clean the float". Har har har.....
there's all kinds of stuff attached to this thing.
So....can anyone tell me any info about…Continue
Posted on September 2, 2017 at 1:14pm — 11 Comments
Just in case anyone was wondering, the work is still in progress on Diggity Dodge. I've had to limit my strenuous activities to stop burning off more than I put in as far as nutrition/calories. Being underweight is no fun and causes health issues too.
On to the progress...I have the kitchen wall almost finished with the Luan. Just a couple of small areas on the sides to cut and fit.…Continue
Posted on August 28, 2017 at 11:13am — 4 Comments
I did a test run fitting the stove in a couple nights ago, and it fits level. No more sticking out from the bottom and it's a good tight fit that has no gaps around the edges. YEY! I did a little corner cutting today so it sits back more flush with the counter in the front like it's supposed to. Excuse the little pieces of wood on the wall there, they were just set there out of the way for a minute.…Continue
Posted on August 13, 2017 at 9:00pm — 9 Comments