Never never land...Never EVER count on a job being fairly easy in these things.......

I THOUGHT....yeah..this is what I get for thinking...
that this was going to be a fairly easy job to do on this heater duct that is crushed by the frame of the couch/bed. Now, looking over this couch and how it is bolted together with no working room anywhere to dismantle it and then get it back together, I decided that was not happening. (I am reminded of Lakota's comment on ablog about an RV being built around a cabinet. I think this RV was built around this couch. LOL)

I was able to get the duct out from under the frame with not too much trouble,and thank goodness for small miracles there were no tears or holes, then ran it over the frame. But, as soon as you put the couch back into position from a bed the couch top frame was crushing it. Not near as much, but I no likey that.

So, I thought of notching the frame enough to fit the duct...but there is no working room to do that and it would weaken it. Nope.

Last resort, the old shag carpet had to go away at some point, it's filthy and stinky with mouse pee/droppings. I knew that was going to be a job. Little did I realize just how bad it would be......

{{RANT BEGINS}}

There are TWO layers of carpeting there,(WHY??) just like the wheel well cover, and a half inch of foam underlay beneath that. If I take that out, it will give a couple inches of room for that duct.
Uh huh...yeah. Off to work I go on it. Staples and glue and nails...oh my! And let's deal with wiring that is nailed to the floor through the carpeting in a highly difficult place to get to, that leads to a screwed in pump of some kind for a city water hook up. (I think)

Two hours I worked on that and it is no where near done. Sweating profusely because of the high humidity and less than a foot of working space I have to crawl into. Just to fix a crushed section of duct. Blimey!!

{{RANT ENDS}}

Probably could reduce the size of the duct, but then I would have to adjust the vent hook up etc. to accommodate that and I don't think it's a good idea to reduce the airflow.

I've started it, I might as well bite the bullet and finish it. I'll need more blades for the utility knife soon. ;-)

Good news, we did get some rain. Enough that the grasshoppers should get a quenching. ;-)

And a thought just occurred to me. Who says the duct and register vent has to stay where it is? It's mine now, I can do what the heck I want. Maybe....I can relocate that and solve the whole danged problem.

Hmmmm.......I'll be back. :)

The following is an added edit after I took a look at something:

LET'S PLAY MAKE BELIEVE>>>>

Make believe the cardboard box in the picture is a small wood box constructed to house the register vent and duct.  Imagine the grey duct in the picture not being visible, that will have to be cut down some. There is just enough room between the couch and the wall to build a box to redirect this vent/duct.  Can anyone think of a reason this will be a bad idea?  If it works, it's going to save me a ton of work and I'll like it much better for accessibility too.


This would also make for a nice little shelf to set "stuff" on.

Whatcha' think ya'll?

Views: 129

Comment

You need to be a member of Good Old RVs to add comments!

Join Good Old RVs

Comment by Ken and Cindy Haney on June 13, 2017 at 7:40pm
Hi Tina, on your shelf thing I think you will have a nice end table that is also a vent. Good thinking.
Comment by Tina on June 13, 2017 at 7:39pm

Edit that last post, the vent does NOT center on the housing.  I'll try to load a pic later to show what I got.

Comment by Tina on June 13, 2017 at 7:38pm

Well, wuddya know.....I found one in the "junk drawer" of the RV where my brother kept all the itty bitty stuff.  LOL  I might go ahead and order one just in case one gets left behind.

Thanks all.  :)

This moving of the duct and register vent is turning into a problem. I have exactly 5 3/4" to work with building a box, or the couch/bed will hit it as it is moved up or down.  The size of the duct (4") and the housing that it fits into to adapt to a rectangular register is not working out real well. The vent does center on that housing,.  It's weird  This is going to take some more thinking for sure. I've looked at reducers, I've even looked for round vents....not sure what I'm going to do there yet.  Something will hit me, just probably not tonight as tired as I am from that carpeting ordeal.  

Comment by Russ Johnson on June 13, 2017 at 5:59pm

I should have waited, LOL. Tina knows what to get now for sure. And yes brilliant minds will sail right along.

Comment by Dawn Michelle on June 13, 2017 at 5:55pm

Hahah Russ - brilliant minds think alike!

Comment by Russ Johnson on June 13, 2017 at 5:54pm

There will not be a pressure regulator, Tina. That is something you have to purchase and attach to your fresh water hose. Here is a link to the one I got: https://smile.amazon.com/Camco-40055-Brass-Pressure-Regulator/dp/B0...

Comment by Dawn Michelle on June 13, 2017 at 5:48pm

Oh, and there are fancier regulators with gauges - we used this type the two years we full-timed back 10 years ago and they worked just fine so saw no reason to go fancier with an older rig...maybe these newer ones that have washing machines and icemakers in the fridges?

Comment by Dawn Michelle on June 13, 2017 at 5:46pm

Pressure regulator: https://www.amazon.com/Camco-40055-Brass-Pressure-Regulator/dp/B003... - look around anything you found in the bays from the PO - it might still be attached to the water hose.  It's standard RV equipment.  If you don't have one - order two :-)  They are very easy to leave at the RV sites because you attach them between the camp spigot and your water hose.  

Comment by Tina on June 13, 2017 at 5:43pm

Just occurred to me, maybe that faucet is to drain my fresh water tanks. DOH!

Comment by Tina on June 13, 2017 at 5:41pm

I know I saw something on the outside the other day that said "city water", and it's on the side where the sink is if I remember correctly. I'll look for that tomorrow and see if there a pressure regulator anywhere near it too.

Members

HOW TO MEMBER POSTS

  •         How To Links 

-Search Good Old RV's

-Start a New Group 

-Roof Repair Photos & Products

-Repair an RV Roof

-Pick Roof Sealer   

-Restore Aluminum

-Paint Fiberglass  

-Restore Old Finish  

-Restore A Class C  

-Service a Used RV

-Understanding RV Electrical Systems 

-Install and Wire RV Battery Banks

-Hook Up Batteries

-Get RV Insurance   

-Gas vs Diesel Trucks 

-What to Look For When Buying a Used RV

-Jack Installs Fuel Injection in his Dodge

 RV ARTISTS 

 Paige's VintageTrailer Art  

 Paige's VintageTrailerFabric

 Artist Roads                                            Sandy's Stained Glasshttps://www.pinterest.com/pin/552605816752050167/     

                      

COME JOIN US on GOOD OLD RVS

If you love classic and vintage RVs then come Join us. Come on in and have some fun. JOIN HERE NOW

Forum

Ski-Tow Puma users group?

Started by Melinda in General Discussion Forum on Wednesday.

Safe-T-Plus Steering Control 8 Replies

Started by Paul Lord in RV Repair & Maintence. Last reply by Paul Lord yesterday.

Manual

Started by John Lonewolf in RV Repair & Maintence on Sunday.

Blog Posts

Looking for 1960 - 1980 Vintage Pop Up Campers

Posted by Tom Willis on June 13, 2018 at 1:30pm — 1 Comment

Four year summer project

Posted by Old soldier on June 10, 2018 at 7:31pm — 1 Comment

Off Grid Power OGP, needful things

Posted by postman on May 30, 2018 at 7:00pm — 2 Comments

Brakes,

Posted by Lakota Wolf on May 12, 2018 at 8:25pm — 3 Comments

Videos

  • Add Videos
  • View All

JOIN US - COME ON IN!

If you love classic and vintage RVs then come Join us.

 Come on in and have some fun.         JOIN HERE NOW!

 Dedicated to a simpler, more rewarding and fun way of life in a Good Old RV... 

Vintage Travel Trailers, Vintage Campers, Camper Restoration, Bus Conversions, Vintage RV Forums, Old RVs, Tiny Homes, Boondocking

YOUR OWN GORVs T-Shirt!

A work of art by member Paige Bridges

Get your Good Old RVs T-Shirt HERE

+++++++++++++++++++++++++++++

 Disclaimer - Please Read it

Enjoy this site and use it totally at your own risk.

By using or viewing this site YOU agree to Hold Harmless anyone associated with it including other members. Also, YOU agree that YOU are solely responsible for ANY and ALL actions, results or damages. Members "opinions" are just that and any repair or alteration comments or recommendations are by folks who are not licensed repair  or mechanical professionals. Any repairs or modifications you do totally at YOUR OWN RISK. Use licensed professionals for all work to avoid possible serious injury or damage. Use  banks for purchases. You could get computer viruses or hacks. Have fun!

Copywrite & Trade Mark Registered GoodOldRV© ,GoodOldRVs©, GoodOldRVs.com©,GoodOldRVs.net©,GoodOldRV.Com©

© 2018   Created by Russ Johnson.   Powered by

Badges  |  Report an Issue  |  Terms of Service